power supply connector pinout

most of the current power supply fan design for the blow or side blowing mode, if it is on the blow, the fan is fixed in the power supply cover, when the demolition, it is important to note that the fan also has a power cord connected with the internal PCB, demolition, shou

My motherboard is a 24PIN power interface, the power is 20PIN interface, compared, the more out of the interface is (+12V, +5v) and (+3.3v, GND) Two groups, now the motherboard only one +3.3v output used in the SATA power sockets, Want to use a large 4-pin socket to transfer into the 4-pin motherboard power

provides requirements for "limit supply voltage" and "Recommended operating voltage", which may be included in the parameter "recommended operating voltage" for "power Noise", which is not necessarily provided separately. The "Power Noise" is the focus of this paper and will be discussed separately.The above example shows that the problem of

supply is to convert a 220 v ac to a DC power available for the PC. Generally, the power supply converts an AC to 12 V, 5 V, or 3.3 v dc. 12 volt DC is used to drive a device with a motor, such as a hard drive and a CD-ROM drive. 5 V and 3.3 V output are used to supply diff

graphics card 12V electricity, so a power supply 12V output power will determine the strength of the power. Sometimes although a power supply rated power, but its 12V output

Are you going to have a power supply to get him powered on without a motherboard? The ATX 20pin has a non-stop bayonet on it, and it's facing itself, and then it's down to the left of the line. 4th and right, 4th, get these 2 connected. Green and any one black, black is ground! Special attention: 1, the PC power supply