raspberry pi zero input voltage

Bought a Raspberry Pi zero W, thinking of using a common micro data line to achieve the SSH Raspberry Pi + network + Remote Desktop target, toss for a long time finally success, words not much to start the whole.This article mainly deals with how to connect to the

0. Power supply is micro USB (Android power connector) 1. Download the operating system from the official website and write the memory card with Win32diskimager. 2. Locate the IP and set the static IP under the router: Command: sudo vi/etc/network/interfaces Switch Auto LoIface Lo inet LoopbackIface eth0 inet StaticAddress 192.168.1.88Netmask 255.255.255.0Gateway 192.168.1.1Allow-hotplug Wlan0Iface Wlan0 inet ManualWpa-roam/etc/wpa_supplicant/wpa_supplicant.conf 3. Computer network cable direct

Raspberry Pi 3 Study notes (3): Chinese environment setting and input Method installation If you are installing a Raspbian system, for friends who are not accustomed to English, you need to set up Chinese and install the corresponding Chinese input method, if you install Ubuntu mate, you do not need to set up Chinese

　　The GPIO pin has two modes board and BCM.1.GPIO output Control LED：　　Code:　　　　(1) Using board mode, GPIO.setmode(GPIO.BOARD) . Pin 35th is GPIO19 under BCM.(2) Set pin 35 to output mode,GPIO.setup(35,GPIO.OUT)(3) on the GPIO35 pin output high level, can also be Gpio.high2.GPIO interface for input signal：　　Circuit diagram　　When the switch is off, the GPIO23 is the high point level to obtain the input signa

Input command: sudo apt-get install fcitx-sunpinyin, you can download the Chinese Input method package.Command format: sudo apt-get install package is to download the installation packages. The Apt-get (Advanced package Tool) is the application Manager for Linux.Select System: Preferences: Personal: Language supportKeyboard input System: Select FCITXConfigure the