redistribute static rip

Floating static route*Note: This article is intended for the majority of users to learn, some of which will mention some professional Internet terms, or abbreviations. If you do not understand the network, you can learn and explore it together. If you have any questions, you can add QQ or YY. (QQ: 914560310, YY: 283755973) "//" is not a command output or description.Let's talk about floating Static Routing.

"Experimental Environment"Packet Trace 5.3 simulation software."Experimental Steps"1, the first to do IP address planning. (e.g. format) Network Name Network address Subnet mask Gateway Host IP Vlan1 10.10.1.0 255.255.255.0 ----- 10.10.1.110.10.1.2 Vlan10 192.168.10.0 255.255.255.0 192.168.10.1 192.168.10.101192.168.10.102 Vlan20 192.168.20.0 255.255.255.0 192.168.20

"Data Collation" Cisco [CLI, Static, RIP, EIGRP, OSPF]3.NBSP;CLI{1) Set password, interface IP address router>router>enablerouter#router#configureterminalrouter (config) # Hostnameaa (config) #enable secretapwda (config) #interface fastethernet0/1a (config-if ) #ip address10.1.1.1255.255.255.0a (config-if) #description yourdesca (config-if) #no shutdowna (config-if) #line console0a (config-line) #password c

Packet Tracer6.0 Static Routing, rip routing, ospf routing configuration, tracer6.0ospf OSPF Dynamic Route configuration Scheme First, we cleared the RIP configuration information configured in the router in the previous article. R1.R2. R3 cleared the RIP configuration in the previous article according to the method. -

The network topology diagram is as follows Divide the network segment well I'm so divided.PcHere only screenshot PC1 content, PC2,PC3 content according to the design of the network segment to fill outNote that when you're done, remember to point to the bottom right corner of the app RouterStatic routing ConfigurationPort IP Static route table Attention After each PC and R are configured, ping RIP p