reverse nslookup command

Refer: http://www.renhaibo.com/archives/29.html     We are familiar with the ping command. It is a command for checking network conditions. When the input parameter is a domain name, it will be queried through DNS, however, only records a and cname (

NSLookup -Qt = mx Email server IP address or domain name The domain name or IP address of the specified DNS server. Usage:Query IP addresses The simplest use of NSLookup is to query the IP address corresponding to the domain name, including the

read the basic requirements of this article:1. The use of the cmd command has a certain basis2. The basic principles of DNS and common concepts have a certain understanding, such as host, alias, forward lookup zone, reverse lookup zone, and so on.3.

nslookup command Summarydefinition of 0.nslookupNslookup is a command-line tool that Microsoft publishes to detect and debug DNS servers. Two modes: one. Non-interactive mode    nslookup–qt= type target domain name  (the default query type is a

The nslookup command is used to query DNS records to see if domain name resolution is normal and to diagnose network problems in the presence of a network failure. The use of Nslookup is relatively simple, mainly the following several uses. 1.

I. Host directiveFormat: Host [-A] FQDN [server]HOST-L domain [Server]Options:-A: Represents a list of all relevant information about the host, including IP, TTL, and error-removing messages, etc.-L: If the next domain setting allows Allow-transfer,

1 DNS IntroductionDNS (domain Name System) can provide valuable data during the detection process, the basic function of DNS is to convert the domain name to an IP address. (If you don't know much about DNS, it's going to take a lot of effort!) Now

Nslookup is a command-line tool that monitors whether DNS servers in the network can correctly implement domain name resolution. It is available in Windows nt/2000/xp. This article is mainly for the mailbox MX records and related query methods to do

First, the question:The Domain Control Server DOS window runs the nslookup command prompt as follows:Second, reason analysis:The main reason is that the DNS server for the domain control server does not have a reverse lookup zone set, and the

BackgroundUser A Domino mail server was hung up and a new one was built, resulting in a pile of back letters. Here are two of these questionsQuestion one:No route found to domain xxx.com from server xxx/xxx. Check DNS configuration."Issue Tracking"1.