samsung phone to buy

A, switch do not Disturb mode? (G6000) 1. In the case of Do not Disturb mode has been opened, drop down screen top curtain. (Note: Do not display the Do not Disturb icon in the upper left corner when not scheduled for activation.) ）2. Click "Disable".3. Do not Disturb mode has been closed. Second, block application notifications? (G6000) 1. Under the Standby page, click "Application".2. Click "Set".3. Click "Sound and Notice".4. Click "Application Notification".5. Click "Stop".6. Turn on the

Because all the Samsung mobile phone weather components are not at the factory display on the mobile desktop, so we need to drag it out, the specific steps are as follows 1. Slide the screen left or right in the main screen select the screen where you want to add the group, and then close the middle with two fingers diagonally. 2. Click on the screen "Panel" as shown in the fol

Samsung mobile phone G9208 support fingerprint identification sensor function, which can improve the safety and convenience of the device, no longer need to worry about security. To set this feature, follow these steps: 1. Under the Standby page, click "Application". 2. Click "Set". 3. Click "Lock screen and security". 4. Click on "screen lock type". 5. Select "Finger

1. Samsung Android mobile phone removal software is in the mobile phone's "application", we are in the mobile desktop into the application management, as shown in the following figure. 2. Then click the "Set" icon in the application. 3. After entering, in our four tabs click on the rightmost "General" tab below the "Application Manager" as shown in the figure. 4. Into the

Samsung A9 Mobile Phone has filter effect, this effect can reach the beauty effect we want, let's take a look at the specific use of beauty effect photography techniques. 1. In the standard mode, click on the "Camera" to enter, this we still have to go into the photo. 2. Then we found the "filter effect" icon in the photo interface. 3. The default state is no effect, we click on "carto

1. Clean the contact point of the battery and cell phone battery, and see if the contact point is bad (the contact is undesirable also can cause this kind of situation).2. Connect the data cable to the computer (charging is normal).3. Try replacing the data cable (whether there is a problem with the USB cable).4. Change the battery (whether the battery aging or bad damage, when the battery display problem). If the problem persists, we recommend that

If you need to set the phone's built-in ringtones to ring tones, you can follow these steps:1. Under the Standby page, click "Application".2. Click "Set".3. Click "Sound and Notice".4. Click on "Ringtones and beep tones".5. Click "Ringtones".6. Select the SIM card where you want to set the ringtone, for example, select "SIM1" and click "Ringtones".7. Select the ringtone you want to set. (Note: Click "Add Ringtones" to set the phone bell or the song th

1. As shown below we just drop the notification bar on our mobile desktop and click "Move Data". 2. Once again, we'll find the "application" option in the interface and open the entry. 3. Click "Set". 4. Click on the "network share and mobile hotspot" option, which is the option for us to operate. 5. Click "Move Hotspot". 6. Slide right in the upper right corner of the screen switch, then the status bar will appear on the left of the hotspot icon

Radio function before we use this application, we must connect headphones that act as radio antennas, because it is necessary to accept the antenna, this is the basic common sense, your friends are ready and small to see About A5 (2016) (5.1.1) Use the radio features details bar.1. In standard mode, slide to the left of the main screen page.2. Click "Tools" after sliding you will see a lot of tools, as shown below.3. Click on the "Radio" option in the tool interface, and then click on it to ente

Note: Some software can not be installed in the SD card, while some applications are installed in the SD card some data it is still cached in the phone, the problem may be to improve the performance of the application done, but the amount of data will not be very large. 1. We clicked "Application" in Samsung mobile interface and entered, the effect is as follows. 2. Click "Set". 3

When we call outside or in a noisy place, may turn the volume to the maximum, also can not hear each other's voice, there may be several reasons, such as the other microphone or their own handset has problems, such as the current signal state is not very good, however, anyway, the voice of the handset is small, This also directly affects the quality of the call. and Samsung mobile phone volume is small, an

The previous description of what the procedure click Mode is, the following we want to introduce is the click Mode Open, because the Samsung mobile phone models have a click mode so here is not too much to introduce other useless things, we go directly to the topic to see How to open the click Mode, specific below. 1. Under the Standby page, click "Application".2. Click "Set".3. Slide up the screen and sel

If you want to change the WLAN hotspot timeout, follow these steps: Note: Please open the WLAN hotspot first, click here to view the open method. 1. Under the Standby page, click "Application".2. Click "Set".3. Click on "WLAN hotspot and network share".4. Click "Move Hotspot".5. Click "More".6. Click "Timeout Settings".7. Choose the appropriate time-out period, such as "10 minutes".8. When the settings are complete, the WLAN hotspot will automatically close if there is no device conne

Samsung mobile phone sm-w2016 supports the video stabilization function, which can be used to reduce or eliminate the blurred image generated by camera shaking during recording video. To turn on this feature, follow these steps:Note: When the auto-chasing function is started, the video stabilization function cannot be used.1. In standard mode, click on "Camera".2. Click the "Set" icon.3. Click on "Video sta

If we have to connect to the computer, then we have to turn on the USB mode, because the Android phone must be USB mode to connect the computer, otherwise it is unable to connect the computer Oh, okay, let's take a look at the Open USB mode tutorial 1. In Samsung Galaxy S5 4G We clicked the "Apps" option, which is as follows.2. Click "Set".3. In the access interface we found the following "About Devices"

Easy mute function means that when you have an incoming call or alarm clock, you can put the palm on the screen or flip the device to turn off the sound of calls and alarms, if you want to turn on the function, please follow these steps:1. In standard mode, slide the screen to the left.2. Click "Settings".3. Slide up the screen and select "Advanced Features".4. Slide the screen up and click "Easy Mute".5. Click on the "Off" right side "slider", show "open" Representative open.When you have an in

opening, the screen can appear assistant menu icon, click on the icon. 7. Turn down to Page Three and click on "screenshot". Note: If the cell phone does not screen properly, it is recommended that you: 1. Check the operation mode is correct. 2. If the method is correct still cannot realize, need to back up important data (contact person, photograph, memo, etc.) Restore factory setting. If the problem persists,