simplex network interface card

Step One Install the wireless network card driver and client software, after the installation is complete, as shown in the following figure. Step Two Enable the analog AP feature. 1. Select the advanced option in the client software. 2. Softap mode , select " open ", prompt "Confirm open Softap mode", click " Confirm ". The "Setting up Softap mode" is displayed, and then you are prompted "You are

-degree angle just like inserting the memory. Then, the two antennas on the edge of the expansion slot-white and gray-marked with "MAIN" and "AUX"-are connected to the corresponding bayonet on the wireless network card. For models with built-in antennas but with expansion slots designed on the front of the fuselage, there is no big difference between inserting built-in wireless NICs and connecting antennas,

, which is automatically changed by default. Note that the capitalization units are different (same as-u).Devices: Custom monitoring of the network card, the default is all monitoring, using the left and right key switch. If only monitor eth0 command: nload eth0 method Two, Iftop tool SOURCE Package Path: Http://www.ex-parrot.com/%7Epdw/iftop/download/iftop-0.17.tar.gz 1, Iftop

encrypted, there is no security problem. The ability to simulate a VPN network card can be directly connected to the internal VPN server from outside the company, and then access the services within the company. Whether you want to find network management, or even Lotus note to grasp the data, can be the desired compensation. Workaround: The first step, after

to display the network card real-time traffic information. By default, Iftop displays the traffic information for the first NIC of the system, and if you want to display the specified NIC information, you can do so through the "-i" parameter.(1) Iftop Output Interface DescriptionExecute the "iftop-p-I em1" command to get a typical output

). Figure 1 Click "view status" to enter the "Network Connection status" window. Here, you can set basic parameters such as the IP address, gateway, and subnet mask of the NIC. Click "OK" to close the window, and then click "manage wireless networks" in Figure 1. Then, the "manage wireless networks" window is opened. 2 ). Figure 2 Click "add" here, select "manually create network configuration file" in t

]#./atl.shShutting down interface eth0: Device status: 3 (Disconnected)DetermineClose Loopback interface: [OK]Eject loopback interface: [OK]Popup interface eth0: Active connection Status: activatedActive connection path:/ORG/FREEDESKTOP/NETWORKMANAGER/ACTIVECONNECTION/1Determine[[email protected] init.d]# chkconfig atl

Computers generally need to configure the network card, so that the normal connection to the Internet to use. In the use of the process, there may be a network card problems can not be connected to the Internet, the common main network c