solaris ping command not found

After the boot found that the computer can not connect to the network, and then pull out the DOS window. By pinging the test, you quickly determine that the fault is now on the router. So check the router, found that the fault is due to the router and external network connection of the network cable off. The problem is resolved after you reinsert the network cable. Computer can not be connected to the Inte

In fact, the computer can not access the Internet can be divided into the following reasons, the system's IP settings, network cards, modems and line failures. Troubleshooting hardware and wiring problems, we can use the ping command to quickly detect network conditions. Step one: First of all, we click on the system in the beginning of the operation, in the Run bar to enter CMD

Recently, when implementing the MSN direct project, we need to use the VPN + ADSL solution to connect the Sigma server to the launch device on the TV tower. In order to test whether the network works normally, the two sides need to cooperate and ping the command to determine whether the network is connected. As TV Tower only allows debugging on Tuesday afternoon, debugging time is limited, and manpower is l

= testping). Pack () Test.mainloop ()Created window programs such asIf the feeling size is inappropriate, you can use, such as Test.geometry (' X-ray ') to set the window to the size of the pixel, remember that × is the letter is not a symbol, window parameters here not much to sayNow let's see if clicking on the Network Monitor button does the required functionality.So, in a graphical interface to implement the ping

1. Network Tools: ifconfig, ping, netstate, Redhat command and graphical settings of ip, finger, nslookup, ifconfignetstateZookeeper 1 ip ad view Nic ID 2. View Nic information in ifconfig 3. Disable the NIC 4. Start the NIC 5. configure a temporary ip address for etho Sudo ifconfig ethoIP address 6. ping Command