NFS file system of Linux virtual machine on the Development Board
Http://apps.hi.baidu.com/share/detail/48189956
Today, I did an experiment on embedded applications.
How can I run cross-compiled applications on your host on an embedded system?
Here I chose to mount the NFS file system over a network.
My lab environment:
The host machine is a virtual machine cento
Log on to the beso_wifi Development Board under the Virtual Machine and install the gdb debugging tool for the graphic interface.
Due to development and laziness (I don't want to install linux directly), I spent some time studying how to log on to the control DEVELOPMENT BOARD UNDER VMware Linux. The specific process is as follows:
I. Required Software and Hardwa
Here are my IP settings: Local Connection IP Address: 192.168.1.23 subnet mask: 255.255.255.0 Default Gateway: 192.168.1.1 nbs
The following are my ipsettings:Local Connection IP Address: 192.168.1.23Subnet Mask: 255.255.255.0Default Gateway: 192.168.1.1Preferred DNS: 202.96.128.86Development Board IP Address: 192.168.1.230Subnet Mask: 255.255.255.0Default Gateway: 192.168.1.1Preferred DNS: 202.96.128.86Virtual Machine Ubuntu IP: 192.168.1.108Subnet
If you want to own a Development Board without spending any money, you can create a virtual development board by yourself.
A Virtual Development Board is a board simulated by QEMU. It is actually a
3. uboot uses the TFTP protocol (disable the firewall of Ubuntu and XP, and disable anti-virus software)(1) uboot itself transplanted the Protocol to connect the network cable
The Development Board and the computer can be pinged directly.The Development Board is connected to the vswitch, and the computer network cable is also connected to the vswitch.The same route as the vswitch.If the connection is wirel
After two days, it almost crashes. Finally.
The Development Board is directly connected to the PC network cable (note that it is not a common network cable, but a specific network cable ).
PC configuration: You need to set an IP address for local connection, which is in the same network segment as the IP address of the Development Board of the virtual machine
1. Do not use router switchesHardware connection:Connecting the Development Board to the PC using a network cableSerial cable connects the PC and the Development BoardUse the command:Ifconfig-aSerial port control to view the network configuration of the Development BoardRoute-nSerial Console view gateway settings for the Development BoardIf the Development Board:ip:192.168.1.8subnet_mask:255.255.248.0PC corresponding configuration: (the same subnet ca
[Reprint] Turn off the virtual machine (VMware) motherboard alarm sound-error bell beep beepOriginal Address:Turn off the virtual machine (VMware) Board alarm sound-error Bell beepGust90After installing the virtual machine VMware, whether it is Windows XP, Windows 2003 or Linux system, there will be annoying beep, espe
First. NFS Service configuration1. Set up the board IP, the same network segment2. Development Board Operation: Ifconfig eth0 192.168.1.203. Test if you can ping the pass: Ping 192.168.1.194. Test whether the board IP is occupied:On the host: sudo ifconfig eth0 down to see if the IP on the Development Board is disconne
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.