1Switch-2 (config) # interface range Tengigabitethernet 3/1-2Switch-2 (config-if) # Channel-group mode onSwitch-2 (config-if) # no shutdown4. Convert chassis into Virtual Switch mode1) Check the chassis PFC mode to ensure the same 2 chassisStep 1switch-1# Show platform hardware PFC modeEnsures that the PFC operating mode matches on both chassis, to ensure that the VSS comes up in SSO redundancy mode.Step 2switch-2# Show platform hardware PFC modeStep 3Switch-1 (config) # Platform hardware VSL P
802.3afTwo power supply modes are supported., 1236Or4578. Supported5Power level: 0: Default15.4 million1:4 W2:7 W3:15.4 million4: Undefined, extended. CiscoThe previous Ethernet power supply is6.3 millionCisco's earlier Ethernet power supply technology is as follows: Power panelUse45,78Power supply. Inline powerUse12,36Power supply, need to combineCDP. Fully supported802.3afThe product is as follows: Catalytic 6000Platform: WS-X6148-45AFWS-X6148-21AFSub-cards required:WS-
on the two switches matches, confirming that VSS is in SSO modecisco-2#show Platform Hardware PFC mode//Verify that the PFC operation mode on the two switches matches, confirming that VSS is in SSO modecisco-1# Platform Hardware VSL PFC mode pfc3c//set the PFC operation mode for switch 1 to PFC3C, which is optionalcisco-2# Platform Hardware VSL PFC mode pfc3c//F
802.3AF supports two modes of power supply, 1236 or 4578. Supports 5 power supply levels:
0: Default 15.4W
1:4w
2:7w
3:15.4w
4: Not defined, extended use.
Cisco's previous Ethernet power was 6.3W
Cisco's previous Ethernet ┑ paragraph 跞, lt;br/>power panel uses 45, 78 power.
The inline power uses 12, 36, and needs to be combined with CDP.
Full support for 802.3AF products are as follows:
Catalyst 6000 Platform:
Ws-x6148-45af
Ws-x6148-21af
Need to add a child card: WS-
With your password.
Use the no shutdown command on interfaces that are being used.
If you use the show ip interface brief command, every interface that you want to use shocould be up.
Type config-register 0x2102
Press Ctrl-Z to leave the configuration mode. The prompt is now hostname #
Type write memory or copy running-config startup-confi
G to commit the changes.
Example of a Password Recovery on the Catalyst 6000 MSFC Module
Switch (enable) show module
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.