what use of switch

Speed-limiting switches are typically on three or more switches, and the new switch model two-tier device since 2008 can achieve the QoS speed limit of 1Mbps, such as the Cisco 2960 series switches. After this, most of the domestic standard

Experiment on single-arm routing using a layer-3 Switch In the real environment, sometimes the gateway is not necessarily enabled on the router, sometimes the single-arm routing function is not necessarily connected to the interface on the router,

Today, the tutor told me about the company's network topology, related to the switch, the basic concept of routers and principles, I am not very clear, so on the internet to learn the information to learn a bit, and then feel that this article is

Two-layer switch: Two-layer switching technology is a mature development, two-layer switch is a data link layer device, can identify the MAC address information in the packet, according to the MAC address forwarding, and the MAC address and the

Two-tier switch:The second layer switching technology is more mature, two layer switch is a data link layer device, can identify the MAC address information in the packet, according to the MAC address to forward, and these MAC addresses and

Two-layer switching technology is a mature development, two-layer switch is a data link layer device, can identify the Mac in the packet Address information, forwarding based on MAC addresses, and recording these MAC addresses with corresponding

Absrtact: Spanning tree algorithms and protocols are the basis for automatically generating network topologies. This paper expounds the content of spanning tree algorithm and protocol, and gives the realization process in Ethernet switch. It is

With the increasing popularity of Mbit/s, Gbit/s, and even Mbit/s local area networks, broadband MAN networks and even broadband wide area networks are widely used. Whether it is Intranet, exclusive, or residential intelligent networks, it is

* Vlan configuration ideas (access and Trunk) (1) create a Vlan and configure a static VLAN on an IOS-based switch: switch # vlandatabaseswitch (vlan) # vlanvlan-numnamevlan-nameswitch (vlan) # exitswitch # configureteriminalswitch (config) #

The core switch is still quite common, so I have studied the displaycpu command details in the switch. Here I will share it with you and hope it will be useful to you. In the LAN operating environment, the working status of core switch equipment is