DB102 DB102-A DB102-B DB108 route settings

After the network adapter is set up, open the browser and type http: // 192.168.1.1; in the address bar ;;. Enter the User Name admin and password dare. This is the default value. If you cannot enter this value, contact your local dealer and telecom)

1. WAN settings

1. turn off 1-7 "virtual circuits". Here we take the off 1 virtual circuit as an example. The method is to select 1 in "virtual circuits" in "WAN" Settings and press "Submit ", enable "enable" select "NO", and then press "Submit" to complete the operation. The other items also do the same *.

2. Set "enable" of 0 virtual circuit to "Yes"

3. Set the VPI and VCI values. Could you tell me the local telecom)

4. For dynamic routing, select "PPPoE LLC" in "Encapsulation Format"

For Static Routing, select "1483 Bridged ip llc" in "Encapsulation Format"

5. Select "Disabled" in the "bridge" option"

6. For dynamic routing, enter "User Name" and "password" in the PPP "User Name" and "password" columns (the specific value is specified by the DSL service provider)

Enter "static IP Address" "subnet mask" "Default Gateway" for Static Routing (the specific value is specified by the DSL service provider)

7. Click "Submit" at the lower part of the page to save the setting value.

Ii. LAN configuration.

The parameters on this page can be left unspecified. Keep the default configuration.

Iii. NAT configuration

Set "NAT" to "NAPT ". Click "Submit" to save the settings.

Iv. Save Configuration

Click "Save settings" in the user configuration bar to go to the "Save settings" page. Click "Submit" to save all the above settings. ADSL will automatically restart and run according to the set parameters.

Note: VPI and VCI must be correct! Tianjin is 0/35 and 8/35!

(T113)