Details on TP-Link router settings (illustration) (1)

The router setting diagram is designed for beginners who build networks. There are no technical points, but the steps are complicated and difficult for them. Here we will show you the entire process of specific operations, this allows you to easily master vro settings.

Preparation of TP-Link router settings

The first condition is that a vro can have four, eight, 16, or more ports. If you have many computers, you can buy multiple vswitches. there are several network cable connections, one in the telecom mode or one in the leased line.) If there are at least two pc computers and only one in the leased line, you can use a vro, however, the meaning of using a vro is lost.
In fact, tp-link company out of the router, such as TP-LINK TL-402M or 401M or other models of tp-link router, most of the ways to open the route almost. The following TP-LINK TL-402M as an example, please see Picture 1

Figure 1TP-LINK TL-402M

The tp-link router is introduced here. You only need to follow the picture to correctly connect the PCs, Telecom broadband modes, and routers to each other, so a network has been set up. the following describes how to enable the routing function.

TP-Link router settings earlier:

If all cables have been connected. we can open a connected PC at any time. enable the network neighbor attribute (Image 2), local connection attribute (image 3), TCP/IP protocol attribute (Image 4), and set the ip address to 192.168.1.2 subnet: 255.255.255.0 Gateway: 192.168.1.1 (image 5) are you sure you want to configure the DNS After configuring the vro.

Note: You can go to the control panel to set the network connection.

Take xp as an example. See the details from Figure 2 to figure 5.

Figure 2 enable the network neighbor attribute

 

Figure 3 Local Connection Properties

 

Figure 4 TCP/IP Protocol attributes

 

Figure 5 set ip addresses

By the way, I would like to remind you that IP address ranges can be set between 192.168.1.2 and 192.168.1.254. Do not set the same IP address to multiple computers. This will cause IP address conflicts. Remember.

Then you can open Internet Explorer on the desktop and enter 192.168.1.1 and press Enter. See figure 6.

 

Figure 6 enable Internet Explorer on the desktop

Enter the user name and password. The default user name and password are admin, which is also written in the vro manual. Enter the name and press enter to enter the vro configuration interface.

Note: The default IP addresses of tplink routers are basically 192.168.1.1, And the passwords are basically admin.