FAQs about vswitch Configuration

I have answered FAQs about vswitch configuration experience, talked about vswitch configuration experience, and learned about vswitch configuration experience, you can easily select your preferred method for vswitch configuration experience. Many methods will make you suddenly enlightened.

It is also a simple and repetitive work, one 6509, two 3524, 15 2924... three times, five times, and two times, adjusted 6509, followed by 2924, while performing on-site training. The customer's network management team has not called any vswitches, but I will list the steps in October 8, 1234, including checking and labeling. It's easy for network administrators to step by step.

The trouble is that when I set a 2924 password, I made a command, for example, enable secret abc123. A lot of people were wrong. I guess it was wrong, password Recovery: Press and hold the MODE key to open 2900xl, instead of using Break or ^ C), and enter the Boot status. Follow the prompts in flash_init; load_helper; dir flash :;

Switch configuration experience: the network manager took a pen and circled the optical jumper four times and pasted it with a tape... Ah, the LINK light is on, and the connectivity is okay! It turns out that this network manager is very familiar with optical fiber, and manufacturing attenuation is a small case. He said that it would be more convenient if there is a optical meter. Rename flash: config. text flash: config. text. old; boot; do not start setup; enable; rename flash: config. text. old flash: config. text; copy flash: config. text running; Change Password; save.

 

Vswitch configuration experience

Next set with WS-G5487 zx gbic connected to 6509 3524 when the problem encountered, with fiber jumper directly connect two devices, it turned out that no connection. Link off, Interface down. I guess the optical jumper is too short, so the optical signal is too strong. He said to the network manager of the other Party: This is easy.

Switch configuration experience the network manager took a pen and made four laps around the patch cord, sticking it with a tape... Ah, the LINK light is on, and there is no connectivity problem! It turns out that this network manager is very familiar with optical fiber, and manufacturing attenuation is a small case. He said that it would be more convenient if there is a optical meter. It's really a trio. We must have a teacher. :-)