Fireworks make fine PC icons

First, the effect of the picture:

Basic steps:

1. Draw a rectangle and adjust the node with a partial selection tool. To increase the stereo effect, each corner is increased to 2 nodes through the Pen tool

2. Add a gradient effect to the rectangle

3. Add a gradient effect to the right rectangle

4. Copy the rectangle and zoom out, as the inner frame screen, the practical launch gradient, add the inner shadow

5. Make screen high light effect, draw a circle, set linear gradient, feather to 6

6. Then draw a big circle, to cut off the parts we do not need, select two paths, modify-combination path-drilling

7. Get the following path, then use the mask to get the inner frame screen we need, select the blue inner frame screen, copy, select the white gradient path just obtained, reverse key-edit-paste as a mask, get the following effect

8. Draw two diagonal lines, make the stereo effect below the screen

9. Use the above high light drawing way to make the high light effect under the screen

10. Use the radioactive gradient to draw the monitor switch button. and copy a light gray circle and place it under the button to produce a stereo effect.

11. Draw the base support shaft with rectangular tool. and use a linear gradient fill

12. Use the rectangular tool to draw the base, use the Pen tool to add nodes and adjust. Use a radioactive gradient fill

13. Use rectangular tool to draw a rectangle high 3 pixel with a radioactive gradient fill, draw the base of the high light effect