The aura of the effect picture looks more complicated. But it's all made up of the simplest effect rings. The production process may be longer, and each small ring needs to be done slowly.
Final effect
| 1, create a new 800 * 800 pixel document, background fill black. Create a new layer press CTRL + R to bring up the ruler, pull two intersecting reference lines, and then, with the center of the reference line, pull out the positive circle selections shown in the figure below to fill the white. |
| 2, and then take the reference point for the center of the circle pull out a slightly smaller round selection, as shown in Figure 2, delete by delete, get a white-edged ring, the effect is shown in Figure 3. |
| 3, with a pen to check out Figure 4, a few closed paths, into the selection and then press DELETE Delete, the effect is as shown in Figure 5. |
| 4, lock the layer after the image filled with orange, the local red brush painted with red, the effect is shown in Figure 6. After the determination, the layer opacity is changed to: 50%, the effect is shown in Figure 7. |
| 5, create a new layer, the same method to make another ring, the effect of the following figure. |
| 6, the new layer, the same method to make other rings, the middle of the ring layer blending mode to "color Dodge", as shown in Figure 9-11. |
| 7. Hide the background layer, create a new layer on top of the layer, press CTRL + ALT + Shift + E-stamped layer. Press CTRL + T to narrow it down a bit, and the background is displayed as shown below. |
| 8. Create a new layer above the background layer, and use the elliptical marquee to pull out the selection shown in the following figure, feather 80 pixels and fill with red. |
| 9, the current layer to copy a layer, the appropriate adjustment of the size and position of the color block, the effect of the following figure. |
[1] [2] [3] [4] Next page
