How does the Win7 system set up IPV6 addresses?

　　 The method is as follows:

1, the installation of IPV6 protocol: Open the Control Panel, and then into the "Network and the Internet"-"network Connection"-Right click "Local Connection", in the Pop-up Properties dialog box click on the installation, and then select "Protocol", click Add, you can install IPV6 to the project list. After the installation is complete, the following illustration shows:

2, set IPV6 address: Open the Control Panel, and then into the "Network and the Internet"-"network Connection"-Right click "Local Connection", in the pop-up Properties dialog box, double-click Internet Protocol version 6 (TCP/IP), in its property box, select Manual, enter IPV6 address " 3ffe:ffff:7654:feda:1245:ba98:3210:4562 "(Since the IPV6 is in the test phase, it is free to enter and determine its address).

3, Test IPV6 settings: Press "Win+r" to open the Run dialog box. Enter cmd and enter the "ipconfig" command in the pop-up msdos window to view all local IP address configurations.

4, the configuration ISATAP tunnel, completes, opens the browser, enters the website "http://ipv6.jmu.edu.cn/" carries on the IPV6 test, on the page, if can see a dancing small tiger, then shows you to IPV6 to visit this webpage, if the tiger does not dance, You are accessing the Web page in IPV4.