How PS Photos

1, first open the photo to be processed

2, because this picture is light so very black, first with ctrl+m adjust the curve, the brightness increased

3, adjust the brightness contrast (image-adjust-brightness contrast)

4. Take a look at the photo taken by the camera with a lot of miscellaneous points on it.

5, with the repair tool to the face of the big noise removed, carefully look at this picture and the previous one on what is different (corner of the shadow of a large)

6, to remove the large miscellaneous points after the first set up a snapshot

7, then select the Filter-Blur-Gaussian Blur, Blur and then build a snapshot, select Snapshot 1, the history of the brush on the snapshot 2 (that is, the fuzzy one)

8, with the history of the brush on the face of the spot on the spot rub, look at the effect, is not much better

9, all the good effect (brush pressure value not too big, otherwise easy to spend, this should be careful)

10, copy the layer, change the mode to filter color, the duplicate of this layer blurred, the effect of the following picture, is not looking a bit artsy shots feeling, hehe

11, a bit too bright, adjust the brightness, ctrl+m adjustment curve

12, the final effect of the following figure (such as the feeling of contrast is not enough to adjust the color level or brightness contrast can also)

13. If you want to change the background, first use the Pen tool to select the portrait

14, all selected to press crtl+ return (convert the path to a selection)

15, the first copy of the picture and background to merge, press ctrl+e down the merge layer, and then point ctrl+j the selection of the picture copied to the new layer

16, casually found a background map, look at the effect

17. This is the original image, and then compare, feel the effect is not bad, this time I do a more rough, if you want to repair better, to be more careful to do, the steps are almost so much

Category:

• PS Getting Started Tutorial