How to connect to and set up a dual-router connection !!

Method 1:

Key Point: Change the IP address of the second router and disable DHCP.

I. First, ensure that only one vro can access the Internet normally.

II. 1) set the computer: it is best to set each computer as follows: Network Neighbor-right-click-attribute, local connection-right-click-attribute, TCP/IP attribute, automatically obtained.

 

II. 2) set the vro.

It is best to refer to the Manual for setting up a vro.

You may need to configure two routers. Name the original vroⅰ I here. The router added after the router is named vroⅱ Ⅱ. If you want to set a vro, use a computer to directly connect to the vro. At the same time, it is best to temporarily remove other unrelated Network cables from the vro. For vroⅰ I settings, refer:

 

 

3. Connection method. Refer:
The network cable connecting vroⅰ I to vroⅱ II is preferably a crossover network cable. Any LAN port of router I can connect to any LAN port of router II.

 

 

In this way, vroⅱ Ⅱ is used as a HUB. In a sense, it can be seen as transparent. Therefore, the status of all computers is equal, and there is no resistance to access bureau network sharing. However, this method consumes two LAN ports. Therefore, you can add a four-port router to connect up to six computers. Because vroⅱ Ⅱ is almost transparent, the gateway of the computer connected to vroⅱ Ⅱ should be the IP address of vroⅰ I like that of ① ②, however, because the DHCP of vroⅱ Ⅱ may cause the gateway to be set to itself when the IP address is assigned to v4.6, You need to specify the IP address above.

Edit recommendations]