Let the integrated wiring technology surmount the difficulty

Understanding the integrated wiring technology is very useful, may be a lot of people do not understand the integrated wiring technology, there is no relationship, read this article you must have a lot of harvest, I hope this article can teach you more things. In order to ensure that the cable will not be scratched to create a "short circuit", in all the steel pipe must be placed plastic mouth. A feasible method is that the threading staff should be carried at any time in the construction of the "mouth", when needed, can be placed at any time, lest because there is no "mouth" and "lazy". Vertical cable through the transition box into the vertical pipe down one level, in the transition box to tie the suspension, to avoid the cable weight full pressure in the corner of the lateral line cable, because this will affect the transmission characteristics of the cable. The cables in the vertical grooves are to be hoisted once per metre. The wire groove inside the cloth should be straight, without winding, and the length should be consistent.

In the integrated wiring technology, on the "Rest line" problem, the cable in the wiring box at the length of the "rest line" should be consistent, and not too long. It is best to divide the rest line by grouped table, and draw straight from the outlet of the line, and the binding point spacing is not less than 50cm. It should be noted that no wire or hard power cord can be used for lashing.

On the issue of marking, cable according to the computer plan for marking, each label corresponds to a 4-core line, the corresponding room and socket location can not be mistaken, in the implementation of this is the most error-prone place. Experience is that both ends of the label position from the end of 25cm, paste light-colored plastic tape, above the use of oily pen marking or affixed to the paper signed after the adhesive tape.

In addition, in general to the proportion of 3% to wear the standby line, the standby line in the main trunk groove, each layer at least one standby line. After threading is complete, all 4 pairs of core cables should be fully tested for pass-and-break. Test can be used in the following methods, the two ends of the cable core stripped open, exposing the copper core. At one end of the digital multimeter dial to the pass test file, two pens to a pair of cable core, at the other end of the cable core frequent, temporary contact. If a intermittent sound is heard on the side of the watch, the test passes, with 4 cores for each cable to be measured. Through such tests, it can be found that the wiring, circuit breakers and the wrong number of integrated cabling technology problems.