"Limited connection" is prompted during wireless connection

When I connect to the wireless device, the system prompts "limited connection". After I have adjusted the wireless router, the desktop can access the Internet, and the mobile phone and notebook can also find wireless signals,
However, I found another problem, whether it's my mobile phone number or laptop, after entering the password via wireless connection, there is a prompt like this: "limited connection ",
Then an exclamation point is added to the wireless signal sign! Enable route settings again. In the "Settings/Basic settings/Internet Settings/Internet connection type" option,
The IP address mode is "static IP", www.2cto.com
Then, "Internet IP Address", "subnet mask", "Gateway", and "static DNS" are set separately"
These IP addresses are certainly correct. The reason why I set the IP address of the router to 1 CIDR block,
Because when I directly connect the machine to the landlord's router, the IP address automatically obtained by my computer is 192.168.1.106,
The gateway is 192.168.1.2. Now I want to use a wireless router as a small switch in my room,
The gateway of my desktop computer should be connected to the static IP network cable of the router as follows: connect the PC with the wireless route using the network cable, the other end of the network cable is connected to the LAN port of the wireless route;
Then connect the Modem line to the WAN port of the wireless router. I found that the DHCP service of the wireless route is disabled, after I enable it, I found that my mobile phone and notebook can be connected to the wireless device through the password. The author ANLJF