Make 3D effect text with fireworks

1, input text after ctrl+shift+p, and then ctrl+j into a synthetic path
2, Ctrl+shift+c clone one. To facilitate my explanation, I named the upper text A, the lower text is b. Select B-Layer text to displacement, after the effect of the following:

3, hide a layer of text, continue to the B-layer text to set, draw a rectangle, placed as the diagram position:

4. Select B and Rectangle at the same time, perform the modification >> combination path >> union, get the appearance as shown:

5. Select Knife tool to cut the lower part of this path, cut down those paths after cutting, then go back to the level board, show a layer, and finally get the appearance as shown:

6, again to the layer a to operate. Still, use the knife tool to cut the lower part and remove those paths below. (note, don't cut too much) to get the picture as shown:

7, to A, B layer, with the pen tool to add nodes, and then use some of the selected tools to adjust the nodes. Finally, the Pen tool is used to close the joints of each path and finally get the picture.

8, execute modify >> combination path >> join, finally you import a bitmap, cut this bitmap, and then paste in the interior.

At this time I still use the pen tool, put them into a closed, the last step, can still be pasted in the interior, but also with the mask, which see the habits of everyone. Pass on my source file.
Modified effect:


怊 months of simple production ideas, with a tween instance (PNG source file):

Use the tween and then break the components, then put several paths Union (union), and then remove the node ....