Making fine fan with PS

The specific steps are as follows:

1 Create a new 900x600px image file

2 Use the Pen tool to draw a path in the image as shown in the picture and load the selection

3 Create a new layer, fill in the selection with a mahogany color

4 Select the rectangular Marquee tool, and its Tool property bar to select the subtract from the selection

5) Perform the selection-transform the selection and set the selection's transformation center to the left, the width of the selection to 105%, height 98%

6) Execute ctrl+j to copy the contents of the selection to a new layer,

7) and create a new layer

8 Using the Polygon Lasso tool, draw a selection, and then fill in the selection of light gray

9 Execution Selection-transform the selection and set the transformation center to the left

10) Rotate the selection-4.8 degrees, then fill in the selection with a darker gray than the original gray

11 Use Polygon selection tool to remove unnecessary slice parts

12 Create a new action: a The fan layer is copied a B, ctrl+t display transformation box, the transformation center point at the rotation point of the fans C, rotate-9.6 degrees D, click the Stop Recording button)

13 in the Action palette, select the action you just recorded, click Play, and create the entire slice

14 Copy all the fan layers and merge

15 Copy the fan-leaf merge layer, and perform the ctrl+t transform, the center point of the transformation is also set at the fan's rotation point, the width and height are reduced to 98%

16 The brightness/contrast of the fan-blade merging layer that has not been transformed is darkened

17 Add bevel and emboss to the fan rack layer, size to 1px other parameters default, copy this layer

Ctrl+t, the Transformation Center point is placed on the rotating point of the fan, rotating-4.8 degrees

19 Perform ctrl+shift+alt+t repeat transform and copy, and all common fan-frame layers are merged

20) Add the same layer style as the normal fan frame for the largest fan frame

21 Copy the largest fan frame, perform ctrl+t transform, transfer it to the other side of the fan

22 to open the pattern that needs to be placed in the sector, drag it into the fan file, put it in the ideal position

23 Press CTRL + Click on the reduced sector layer, load the selection, reverse, and remove the extra parts of redeployment's slice diagram

24) Set the blending mode of the layer of the slice graph to be linearly deepened.

25). The final effect figure is as follows:

Category:

• PS Mouse Painting Tutorial