It consists of bubbles and graphs. The preparation of the bubble part is a little complicated. because there are many highlights, you need to use a pen or other selection tools to make the desired selection area, fill the color or fade, and use a mask to control the edge transition. Final effect
1. create a 800*800 pixel document with the background filled in blue.
2. select the elliptical tool, draw a circle on the background layer, fill in purple, and add a mask to pull the opacity gradient.
3. copy Sphere 1, fill in blue-green color, and add a mask to make a transparent gradient.
4. select the elliptical tool to draw an elliptic image, use the deformation tool to perform deformation based on the shape of the sphere, and finally fill the gradient.
5. the following effects need to be adjusted with patience. The steps are basically the same as the above layer. the elliptical shape is used to deform the sphere and then the color is filled.
6. then, we will deepen the website. Use an elliptical tool to draw circles, raster layers, and smear them with an extension tool. Add a layer mask to control the transition area.
7. select the elliptical box selection tool to draw a circle selection area of the same size as the sphere, and use the stroke tool to draw its side: the size is 1 pixel, and the color is white. Then, the wireframes are outputted. Finally, add a mask to control the transition.
8. use the rounded rectangle tool to draw a circle, raster the layer, and use the free conversion tool to deform the image perspective. The effect is as shown in figure.
9. copy the layer and fill it with gradient.
10. use the pen tool to draw the light receiving part to increase the texture.
11. Use a pen to draw a check mark and fill the color.
12. use the polygon plug-in tool to select a part, then select and delete another part, fill the selected image with gradient color, and move the position up to form a stereoscopic effect.
13. then copy the checkmark image, which is located at the top of the source image layer and changes the color and moves up slightly. this stereoscopic image appears.
14. after the image is created, refine the part illuminated by the light source to further increase the stereoscopic effect and texture of the image, and add the projection.
Final effect:
