Photoshop takes photos into the autumn orange color tutorial

Original

< small map view big picture >

Final effect

1, open the material picture, create an optional color adjustment layer, yellow, green adjustment, parameter settings such as Figure 1, 2, the effect is as Figure 3. This step first turns the main color of the background part to yellow-green.

< map 1>

< map 2>

< map 3>

2, the creation of optional color adjustment layer, the same will be yellow, green adjustment, parameters and effects of the following figure. This step adds yellow to the picture.

< map 4>

< map 5>

3, create hue/saturation adjustment layer, the yellow adjustment, parameters and effects as shown below. This step turns the yellow in the picture into orange yellow.

< map 7>

< map 8>

4, create curve adjustment layer, RGB, red, blue channel adjustment, parameter settings such as Figure 9-11, the effect is shown in Figure 12. This step mainly adds light yellow to the picture's high light portion.

< map 9>

< map 10>

< map 11>

< map 12>

5, create an optional color adjustment layer, red, yellow, green, white, neutral color adjustment, parameter settings such as Figure 13-17, the effect is shown in Figure 18. This step turns the background main color to orange red.

< map 13>

< map 14>

< map 15>

< map 16>

< map 17>

6, create an optional color adjustment layer, red, yellow, white, neutral color adjustment, parameter settings such as Figure 19-22, the effect is shown in Figure 23. This step also adds orange red to the picture.

< map 19>

< map 20>

< map 21>

< map 22>

< map 23>

7, according to the need to add a little orange red, the effect of the following picture.

8, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Execution: Filter > Blur > Motion blur, Angle set to 45 degrees, distance set to 200, after the change layer blending mode to "soft light", the opacity to: 50%, the effect of the following figure. This step of the picture to soften processing.

< map 25>

9, a new layer, stamped layer. Using fuzzy tools to blur the background with noise, the effect is as follows.

< map 26>

10, the use of Lasso tool to select the face of the characters, feather 2 pixels after the creation of curve adjustment layer, appropriate brightness, the effect of the following figure.

< map 27>

11, create brightness/Contrast adjustment layer, the appropriate increase of a point of contrast, parameters and effects of the following figure.

< map 28>

< map 29>

Add a bit of high light to the picture, and then fine-tune the color to finish the final effect.