Three methods to obtain the stable signal of D-LINK Wireless Router

We know that there are many factors affecting the stability and connection speed of wireless signals in practice. The specific factors and solutions are as follows:
I. speed reduction and Stability Improvement now wireless networks are widely used. Due to mutual interference between wireless networks in the same frequency band, 13 frequency bands are not enough for everyone to use. General D-LINK wireless router will have wireless network mode setting function, can fully change the wireless device working mode from 802.11g to 802.11b. Although the speed is reduced, it brings stability benefits. To a certain extent, reducing the transmission speed can make our wireless network more stable.
2. Reduce frequency band interference when we find a wireless network will select a frequency band. Theoretically, too many wireless networks in the same frequency band will seriously affect the signal strength, if your home uses the same wireless signal frequency band as your home's wireless signal transmitting frequency band, then to some extent the two wireless networks will be affected. When the network is unstable, you can replace a signal transmission band through the D-LINK wireless router, select the automatic scanning channel.

Multiple APs and multiple wireless routers do not interfere with each other as long as the SSID name and frequency band are different. Naturally, data transmission will not be affected. If too many wireless networks exist in the same frequency band, interference will occur. Www.2cto.com
III. The DHCP packet rejection service can automatically allocate IP addresses of computers on the network. However, in actual use, DHCP may cause network instability, for example, if the IP address is obtained again after the lease, other computers in the network are using the IP address, or DHCP information is frequently negotiated between the computer and the wireless router. Generally, there are not many computers in the home user's network. You can manually set IP addresses and other network parameters to reduce DHCP packets.
The above is to obtain the D-LINK wireless router stable signal method, hope to help everyone. This article is from