Blank Page (reportviewer) during rdlc Printing)

 

After the rdlc tables are set, the data in the reportviewer tables Table is normal, but when switched to the full mode, this often results in a lot of blank spaces coming out. In the first time, I thought it was not feasible. In reportviewer, it seems that it is normal. How can the format run away throughout the entire batch? If the format is run away during the entire batch operation, it must be the same during printing. Reportviewer displays the stored table of the rdlc, but this is not the case when printing it. Therefore, you need to check the size of the rdlc modified table.

1. go to report first. rdlc sequence table design plane. On the selection menu, choose [sequence table]-> [sequence table sequence], in the [configuration] partition, we remember to export the partition size of the partition table. The partition should be in the A4 straight sequence (partition ratio: 21 cm, partition height: 29.7, left and right upper and lower bounds: 2.5). Remember these values.

2. Audit query report.RdlcThe size value of the [main body] Attention in the attention window. Its attention width is smaller than that of the [optimize table attention) -(left border)-(right border ).

3. Try again after completing the optimization. If you try multiple times, there will not be too many products.BlankStopped.