CentOS/usr/libexec/gconf-sanity-check-2exitedwithstatus256 troubleshooting

CentOS/usr/libexec/gconf-sanity-check-2exitedwithstatus256 problem solved last night to three servers attached to the new hard disk and then restarted, found that one cannot start up. I looked at the data center and connected the monitor. after the boot, the image jumped to the next hop because the server was on... centOS/usr/libexec/gconf-sanity-check-2 exited with status 256 problem solved last night to three servers attached to the new hard disk and then restarted, found that one cannot start. After reading the image from the data center and connecting to the Monitor, the image will jump to the next hop. because the video card is integrated on the server, the visual test shows that the memory is unstable (the memory has been added ), after the shutdown and power-off, the golden finger in the memory is wiped and inserted again. However, this is not a jump, and the test memory is okay, that is, it cannot enter the system. It should be said that the desktop cannot be entered (the desktop is installed when the system is installed ). The following is the error message and solution: System: CentOs-6.3 x86_64 boot after entering the desktop (just appeared mouse cursor), a pop-up error box, prompt: [plain] There is a problem with the configuration server (/usr/libexec/gconf-sanity-check-2 exited with status 256) solution: Reboot, boot the system with the Live-DVD system disk, go to the CentOS system on the CD, open/tmp under the partition where the system is installed on the hard disk, and clear all contents under the tmp Directory, including hidden files and directories. View the permissions of the/tmp directory to ensure that the permission is rwxrwxrwt (it is said that 777 is also acceptable ). Restart the system to enter the desktop.