Admin to run cmd, enter DiskPart
Diskpart>
Then enter the following sequence:
List disk
Select disk 1
Clean
Create partition primary
Active
Format Fs=fat32 Quick
Assign
Exit
Then copy all files in the installation image
If it does not start properly, use the repair command: I:bootbootsect.exe/nt60 I:
Gone are the days when we used to burn CDs and DVDs to install operating. Now all modern operating systems lets you install using PEN drive/usb Storage device/usb Stick. And this article describes step by step guide to format and create bootable Windows vista/windows 7/windows 8 USB Stic K.
Prerequisites:
Windows vista/windows 7/windows 8 ISO or installation files
A 4GB USB 2.0 Storage device (its recommended to use USB 2.0 or USB 3.0 device for optimal)
How to:
Plug your USB storage device. and run Command Prompt and execute the following commands one by one.
Diskpart
Run Disk Partition Utility
List disk
To get disk Index this is used to perform disk partitioning.
Select Disk n
Selects disk n to perform disk partitioning. N is the number for your USB flash drive your obtained from above command.
Clean
Flush your existing all USB drive ' s partitions.
Create Partition Primary
Creates a partition as primary partition.
Active
Set the partition as active to hold bootmgr.
Format Fs=ntfs QUICK
Perform a quick format on the USB Flash drive
Assign
Assign a drive letter to the partition
Exit
To quit Diskpart Utility
Now copy all the setup files to USB storage device ... and that's all.
Re-Boot your PC with it, you'll be able to boot and install Windows vista/windows 7/windows 8 using USB Stick.
Note:if you are trouble to boot with it or unable to boot and try this FIX.
I:bootbootsect.exe/nt60 I:
Where I:is The drive letter of USB Stick