Ease of use of broadband in Linux

Article title: using broadband easily in Linux. Linux is a technology channel of the IT lab in China. Includes basic categories such as desktop applications, Linux system management, kernel research, embedded systems, and open source.
Speaking of Linux, I have always been very concerned about it. large companies like Sun and IBM are promoting Linux. Not long ago, many display computers in Zhongguancun electronic market were pre-installed with Linux. However, in the home market, Linux is not very competitive. The following article describes how to access the Internet in Linux. if you are using Linux, refer to it.
　　
When I was using the red-flag Linux 2.0 desktop system, I suddenly found a problem. I am using Ethernet broadband (the kind of 5-class online users), but I don't know how to access the Internet in Linux. After querying some information, I found that both ADSL and Ethernet bandwidth are based on PPPoE virtual dialing. So I thought, if PPPoE is installed in Linux, you should be able to access the Internet. After the experiment, I finally succeeded in surfing the Internet, and this method is also suitable for various Linux operating systems. I will share it with you below.
　　
Assume that your Nic has been installed. If you are not sure, use the "ifconfig eth0" command. In the network settings, select manual IP address. it is recommended that you do not set the IP address to leave it empty. Then, set the DNS, route, and other settings to null.
　　
　　 Install the PPPoE package
Please download the software package http://www.roaringpenguin.com/pppoe/rp-pppoe-3.4-1.i386.rpm. You can download the file in Windows and then load it to the partitions in Linux by using the Mount command. However, if you open the root/mnt Directory, there are all files on the hard disk, including Windows files. Then install the file. if you are in X-Windows, click the icon of the file to install the file. click it to install the file. If you are on the character interface, type the rpm-Uvh rp-pppoe-3.2-1.i386.rpm in the directory where the package is located to install it.
　　
　　 Set dialer
You must enter adsl-setup on the character interface, and then enter the following content as required:
　　
　　
　　
　　 Dial-up Internet access
After talking about this, it is time to access the internet. in the character state, enter "adsl-start", and Linux will automatically dial the Internet. Enter "adsl-stop" when disconnecting. Everyone now knows how to dial up broadband in linux. don't download one!