Activate the NIC command in linux-general Linux technology-Linux technology and application information. For more information, see the following. Today, the Redhat Linux 9.0 system is installed on the Virtual Machine. When the third disk is installed and startx is being configured, a sudden power failure occurs. The result is not configured to the desktop environment, so the KDE screen cannot be entered. When the system starts, it prompts that the eth0 Nic fails to be loaded, which is probably caused by no activation. However, the desktop cannot be activated, and it can only be activated by using commands. Now we will write down the activation step and share it with you.
1. Enter the netconfig IP Address service network start.
Enter the IP configuration screen, enter the IP address, subnet mask, and gateway, and then click OK.
2. Return to the command line interface and enter:
Ifdown eth0
Ifup eth0
The NIC takes effect and the network configuration is successful.
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.
A Free Trial That Lets You Build Big!
Start building with 50+ products and up to 12 months usage for Elastic Compute Service
