[Help] wireless network connection problems (WPA)

[Help] WPA-Linux general technology-Linux technology and applications. I can connect to an infinite network on the graphic user interface, but I cannot connect to the network on the console.

Iwlist eth1 scanning result:
Cell 02-Address: 00: 0F: E2: 0F: 9E: ED
ESSID: "xxxxxx"
Protocol: IEEE 802.11bg
Mode: Master
Frequency: 2.462 GHz (Channel 11)
Encryption key: on
Bit Rates: 1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s
11 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
48 Mb/s; 54 Mb/s
Quality: 79 Signal level: 0 Noise level: 0
IE: WPA Version 1
Group Cipher: TKIP
Pairwise Ciphers (1): TKIP
Authentication Suites (1): PSK
Extra: Last beacon: 994 ms ago


My wpa_supplicant.conf file:
Ctrl_interface =/var/run/wpa_supplicant
# Ctrl_interface_group = wheel
# Ctrl_interface_group = 0
# Ap_scan = 1
Network = {
Ssid = "xxxxxx"
Key_mgmt = WPA-PSK
Proto = RSN
Pairwise = TKIP
Group = TKIP
Psk = "mypassword"
}

My ifcfg_eth1 file:
# Intel Corporation PRO/Wireless LAN 2100 3B Mini PCI Adapter
DEVICE = eth1
HWADDR = 00: 0c: f1: 06: 94: b9
ONBOOT = yes
BOOTPROTO = dhcp
TYPE = Wireless
USERCTL = yes
PEERDNS = yes
IPV6INIT = no
NM_CONTROLLED = yes
ESSID =
CHANNEL =
MODE = Auto
RATE = auto

My command:
Wpa_supplicant-ieth1-Dwext-c/etc/wpa_supplicant/wpa_supplicant.conf

The result is:
CTRL-EVENT-SCAN-RESULTS
CTRL-EVENT-SCAN-RESULTS
CTRL-EVENT-SCAN-RESULTS

If you replace proto = RSN with proto = WPA, the result is:
CTRL-EVENT-SCAN-RESULTS
Trying to associate with 00: 0f: e2: 0f: 9e: ed (SSID = 'xxxxxx' freq = 2462 MHz)
Ioctl [SIOCSIWFREQ]: Operation not supported
Association request to the driver failed
Associated with 00: 00: 00: 00: 00: 00
CTRL-EVENT-DISCONNECTED-Disconnect event-remove keys



Can that man help me?

Thank you.