FreeBSD starts from scratch-system installation (2)

3. after installation, the settings enter the Nic configuration phase. Generally, the DHCP mode is not selected as the server, so you need to set the server IP address and Gateway. However, it does not matter if you do not set them here, after entering the system, you can set it again. Whether to configure IPv6. it is not required yet. Therefore, select NoDHCP or No to configure it...

3. set after installation

In the Nic configuration phase, the DHCP mode is usually not used as the server, so you need to set the server IP address and Gateway. However, it does not matter if you do not set it here. you can also set it after you enter the system. Whether to configure IPv6 or not, so No DHCP is selected to configure Nic information, write IP address, Hostname, and domain name Gateway Information. Switch to OK and press enter. Select whether to act as the gateway. Select whether to enable inetd and choose not to enable inetd. Select whether to enable SSH. this must be enabled. Otherwise, you cannot log on remotely using CRT or other software. Whether anonymous ftp login is required. generally, after selecting no, the system will ask if it is used as the NFS server and client. if NFS is not used, NO is selected, unless you know that an NFS device exists in your network and need to be accessed or accessed. Next, set the time zone, mouse, and so on. because NO is available, select No. Finally, you will be asked if the package contains a lot of application software and whether to install it. select NO. in Freebsd, it is not recommended to install binary files directly. it is better to compile and install the binary files through ports, which will be more optimized and secure. Select "No" and then create an account. Because the procedure for creating an account is important and involves whether the account can be changed to root, I will explain it separately in the next article.