"Graphics Tutorial" win7+vmware8.0+centos6.4 NAT Internet

Install VM8.0 under Win7, and install multiple virtual machines inside, each virtual machine can access each other, while the virtual machine can directly access the external network, Win7 to ping the system in a virtual machine. In this way, use NAT mode to turn on the VMware Network Adapter VMnet8.

If the virtual machine is required to be accessible, but the virtual machine cannot access the extranet this uses host-only mode.

The application environment for bridging mode is that the virtual machine is independent of the same machine as the host (this is WIN7).

Main note: After configuring the IP in the host, you need to set the IP in the VM virtual machine network configuration, and record the gateway in the virtual machine, the system CentOS configuration IP Gateway and DSN are set to the gateway in the VM.

The host agent in the virtual machine is connected to the Internet process as follows

1. After installing the virtual machine, first configure the host as the WIN7 environment here.

The first step

Step Two

2. Configure the IP above the VM8.0 according to our configured IP

The first step

The second step is to remember the gateway here. 172.17.10.2

3. Configure the CentOS network IP in the virtual machine to edit the vim/etc/sysconfig/network-scripts/ifcfg-eth0. Where the DNS configuration 172.17.10.2, the last reboot can be.

"Graphics Tutorial" win7+vmware8.0+centos6.4 NAT Internet