How to customize fine tuning offsets in CorelDRAW

Q: How do I customize the trimming offset in CorelDRAW?

A: This should be a basic problem, but it is still on the table, because it has a number of similar functions, such as custom corners, custom units and so on.

Adjust the fine-tuning bias of the CorelDRAW property bar, which defaults to 3MM, if any object is not selected. The following illustration is from left to right: default unit, fine tuning bias, and further distance.

Sometimes we want to convert a scale, if the inch to cm or mm, at the edge of the hand and there is no engraved units, the use of CorelDRAW is easy to solve.

For example, let you calculate how many cm is 15.5 inches?

1. Open CorelDRAW and change the default unit to inches.

2, draw a rectangle, the custom length is 15.5

3, cancel the selection, set the default unit is cm

4, click the rectangle, look at the length of the property bar cm is the final cm value we seek.

Other functions such as "Make distance" and other use of good, but also can do a lot of efficient things, we encounter such problems can be freely adapted.