How to set the connection between a universal router and a computer

How to configure the connection between a universal router and a computer when a telephone line arrives at home, connect the WAN port of the universal router with the LAN of the MODEM first, and then connect the computer Nic to any LAN port of the router, you can directly connect the network cable to the WAN port of the router and specify an IP address for the computer. If there are not many computers, we recommend that you manually specify an IP address. Next, we will introduce the automatic acquisition and manual setting methods.
1. automatically retrieve IP settings
(1) Right-click the network neighbor on the desktop and select Properties

(2) Right-click on the local connection and select Properties

(3) Enable the TCP/IP protocol attributes (4) select to automatically obtain the IP address and the DNS server address, click OK, and then run start-run on the computer, Enter CMD, OK. In the Command Prompt window, enter the ipconfig/all command. If the IP address shown in is displayed, the NIC has obtained the IP address from the vro. Www.2cto.com

2. manually set IP addresses
(1) If the network adapter cannot obtain the IP address, or the obtained IP address is 169.254.X.X, manually specify the IP address, set the method, right-click the network neighbor on the desktop, and select Properties. (2) Right-click on the local connection and select Properties. (3) Select the Internet Protocol (TCP/IP ). (4) Click properties. The default LAN port IP address of the router is 192.168.1.1. Therefore, the gateway needs to be set to 192.168.1.1. The red circle number in the figure can be changed to 2 ~ 254 If multiple computers share the Internet, the IP addresses manually specified by each computer must be set to different. Otherwise, a conflict may occur in a LAN.

The DNS server address entered in the red box above is the DNS server address of Shenzhen Telecom. If you are not a user of Shenzhen Telecom, consult your network service provider for the DNS server address, enter the IP address and DNS server address in the dialog box marked in red.
3. Open IE and enter 192.168.1.1 in the address bar to display the vro management interface dialog box.

Click "OK" to go to the management interface of the universal router. The router is connected to the computer correctly. You can set the router to access the Internet. This article is from