How to set up the commercial wireless AP Fat mode

Commercial wireless AP Fat Mode Setup First step, operational readiness

1, switch mode switch

Locate the fat/fit mode switch on the side of the AP shell and switch the mode switch to the FAT file.

2. Power supply and connection

Some AP needs to use the 802.3AF/AT standard Poe Cable power supply, please use the standard Poe Power switch (Poe Power supply) to the AP power supply, the installation is recommended not to access the network, wiring diagram below.

Attention. tl-ap451c, tl-ap301c use DC (DC power) or passive Poe power supply. Connect the computer to the AP's network cable port and use the power adapter to power the image below.

Commercial wireless AP Fat Mode Setup Step two, login interface

1. Set up Operation computer

Please set a static IP,IP address for the local connection of the operating computer. 192.168.1.10, the subnet mask is 255.255.255.0, without setting up gateways, DNS.

2, enter the administrative address

Open the browser, empty the address bar and enter 192.168.1.254, the page will eject the login box after the return.

Attention. If the administrative address has been modified, please log in with the modified address.

3, enter the login information

In the Login box, enter the wireless AP default username and password, are admin, click Login, enter the management interface.

Attention. If you have a user name and password that has been modified, log in using the modified username and password.

Commercial wireless AP Fat Mode Settings Third step, wireless settings

1, into the wireless settings

After you log on to the AP interface, click Wireless for wireless settings.

2, modify existing wireless settings

If the wireless service already has a wireless signal, you can click the settings icon to modify the wireless settings (it is recommended to remove unwanted signals, encrypt useful signals). The following figure.

The specific setup process is shown below.

Attention. When the type is set to a guest network, the host of the guest network cannot communicate with other wireless network hosts. When wireless network internal isolation is enabled, the hosts connected to the same wireless network cannot communicate with each other. The above features if you need to break AP effective (between multiple AP), need to combine VLAN settings, detailed reference to the relevant documents.

3. Add new Wireless Signal

Click New in the wireless service to add additional wireless signals. The following figure.

4. Save Settings

When the settings are complete, the interface prompts "Do you have an unsaved configuration, do you want to save it now?" , be sure to click the Save Configuration button on the right side to save your configuration.

Commercial wireless AP Fat Mode Setup step fourth, address modification

The AP's default IP address is 192.168.1.254, and if the LAN has more than one AP, the administrative address needs to be set to an address that does not conflict with the same network segment for ease of administration.

If the IP address of the first AP is 192.168.1.254, the second AP has an IP address of 192.168.1.253, and the third AP has an IP address of 192.168.1.252 ..., and so on. Click System >> Settings Management can set management IP address, modify and click OK.

Attention. After you modify the address, use the modified IP address to login to the AP's admin interface, save the configuration, or the configuration will be lost after the reboot.

Commercial wireless AP Fat Mode Setup Fifth step, line connection

After the settings are successful, power the AP and connect to the front-end network. Refer to the figure below.

This wireless AP's commercial wireless AP Fat Mode Setup completes, the wireless terminal searches the corresponding signal, connects the Internet.