Install Linux Kernel and installkernel
Ii. AT91SAM9260EK
Download 2.1
Introduction page:
Http://www.at91.com/linux4sam/bin/view/Linux4SAM/LegacyLinuxKernel
Download Page:
A) ftp://www.at91.com/pub/linux/2.6.30-at91/
B) http://maxim.org.za/at91_26.html
(1) Kernel
V2.6.30
(2) maintainer-patch
V2.6.30 (23/06/2009)
(3) experimental -- patch
V2.6.30
(4) board-cfg
At91sam9260ek_defconfig (V2.6.30)
2.2 deployer
Decompress and patch
Copy all patches to the linux-2.6.30 directory after the kernel step is completed.
(1) kernel
$ Tarjxvf linux-2.6.30.tar.bz2
(2) SoC-patch
$ Zcat 2.6.30-at91.patch.gz | patch-p1
(3) board-patch
$ Tar zxvf 2.6.30-at91-exp.5.tar.gz
$ For p in 2.6.30-at91-exp.5/*; do patch-p1 <$ p; done
(4) board-cfg
$ Cp ../at91sam9260ek_defconfig. config
2.3 Modify file
2.3.1 Makefile
Refer to 1.1-Modify Makefile
2.3.2 NAND partitioning
NAND is divided into 1 zone,
Modify the "NAND flash" section in the board-sam9260ek.c, see the appendix "nandpartition"
2.4 Configure driver
$ Make oldconfig
$ Make menuconfig
About make oldconfig 1. If. config does not exist, the default settings for running make config/menuconfig are determined by the default values that are fixed in each Kconfig file. 2. If. config exists, the default setting for running make config/menuconfig is the current. config setting. If you modify the setting,. config will be updated. 3. arch/arm/defconfig is a default configuration file. make defconfig generates the current. config file based on this file. 4. There are many configuration files named xxx_defconfig in the arch/arm/configs folder. If you run make xxx_defconfig, the current. config file will be generated by the xxx_defconfig file. 5. make oldconfig is used to back up the current. config file as. config. old. If make config/menuconfig is improperly set, it can be used to restore the previous. config
2.5. Generate uImage
$ Make uImage
-------------------------------------------------------------------- Full text end ----- xiaobin ----------
Refer to Article 4-Install Linux Kernel
Nand partition (linux-2.6.30, arch, arm, mach-at91, board-sam9260ek.c)
By
/* * NAND flash */static struct mtd_partition __initdata ek_nand_partition[] = {{.name= "Partition 1",.offset= 0,.size= SZ_256K,},{.name= "Partition 2",.offset= MTDPART_OFS_NXTBLK,.size= MTDPART_SIZ_FULL,},};
To:
/* * NAND flash */static struct mtd_partition __initdata ek_nand_partition[] = {/*{.name= "Partition 1",.offset= 0,.size= SZ_256K,},{.name= "Partition 2",.offset= MTDPART_OFS_NXTBLK,.size= MTDPART_SIZ_FULL,},*/{.name = "AT91 NAND my_P1",.offset = 0,.size = MTDPART_SIZ_FULL,//2*SZ_1M,}};