Make a picture of film feeling tutorial

1. Photoshop CS5

2, Nik Software Color efex Pro

Make a picture of a film feeling tutorial:

1, first use PS to open your photos.

Camera: Canon EOS 40D

Lens: EF 50mm F1.8

Aperture: 2

Shutter speed: 1/60s

ISO 100.

2. After opening, copy the background layer (CTRL+J) and change the blending mode to soft light.

3, duplicate one layer (CTRL+J), and change the blending mode to filter color. Now this is the traditional three-layer revision method, the soft layer control details, filter layer control brightness, and control lever is opacity.

4, now try to pull out the appropriate tone, I set the opacity of the filter layer in 52%, the opacity of the soft layer is determined at 83%.

5, now start to cut the photo into the widescreen ratio used for the movie. Using the Crop tool (C), enter a ratio of 7:3 in the property bar, drag the mouse over the picture, and select the range you want to trim.

6, because the screen right corner and the lower left corner of the light drops of water dispersed sight, so consider reducing its brightness, first click on the curve, and then the curve of the upper right corner to drag down to the appropriate position.

7. Reverse the Mask (ctrl+i)

8, the use of brush tool (B), white (contrary to the mask color), opacity 30% (3), wiping the four corners of the lower brightness.

9, stamped layer (SHIFT+CTRL+ALT+E).

10, use the filter nik Software Color efex Pro 3.0 (download address) → film effect →fujichrome Astia 100F.

11, because the filter is a bit heavy, so the opacity will be lowered to 75%.

12, I feel that a lot of movies have a layer of charming cyan, so the next step is to mask a layer of cyan, there are many methods, you can use filters, you can use color balance, can fill solid color, but I used to use the lab curve (personal habits). Image → pattern →lab color → curve → curve A (alt+4), point at the highlight (keep the highlight color), move the lower point of curve A to the right half Georg (if your PS display curve is large, you can hold down the ALT key and click anywhere in the curve). So the color will be adjusted well.

13, the following start to add a black box to the photo, the method may be very stupid. Image → Canvas size (ctrl+alt+c) height plus 1000 pixels (the value is based on the pixel size of the original slice, as long as you want to cut to 16:9 of the value of the higher can), color selection black.

14, the use of cutting tool (C), set the ratio of 16:9, choose the right position to cut (ensure that the upper and lower black box height equal). Finally, image → mode →rgb color, save, out slice.

15, you can give photos in the subtitle position plus text, Chinese and English bilingual, and the movie screenshot times like, and I choose to add watermark ....

Here is the picture, you can refer to the following:

Category:

• PS Image Processing