MHDD repair bad way how to use

1, if the bad way less, we can use MHDD software to shield the bad, can get unexpected results, the following take my wd500g notebook as an example, hard drive bad road shielding

2, this is my notebook in the recent situation, the boot of the hard drive self-test, the hard drive self-test has been difficult, need to press the space bar before the self-test to normal access to the system

At this time, we can use MHDD scan the hard drive, check the hard drive condition.

Now the PE in the toolbox with the MHDD hard disk Detection tool, in this note, must be in the motherboard BIOS check the hard disk mode, see is AHCI mode or IDE mode, MHDD can not be in the hard drive for AHCI mode to sweep to the hard drive

3, save the BIOS settings, restart press F12 to enter the startup item selection interface

4, the choice of 1, that is, my u disk, this is needless to say, as long as the system has been reloading to know how to do

5, run the hard Disk Memory detection scan Tool menu

6, run MHDD hard drive detection

7, the picture is not clear, do not think you have a lot of dizziness, is my hand shaking, here do not move, direct hit return

8, you can see, option 8 is my wd500g, press 8, hit Enter, appeared this interface

Start LBA fills your hard drive with the start sector end LBA to fill your hard drive's bad-track ending sector.

Remap selected on indicates that the repair function is turned on.

Timeout is generally the default for time.

Loop/test REPAIR set to on indicates that the open here is repeated erasure can be repaired play solid bad way.

ERASE off for off.

9, the setup completes, presses the F4 to begin to repair.

Want to cure, have to see a doctor first, press F4 to carry on the whole scan directly!

10, entered the hard disk scanning interface, each long square represents 255 sectors (in LBA mode) or 63 sectors (in CHS mode), the scan can be terminated at any time by pressing the ESC key, and the square from top to bottom indicates from normal to abnormal, read and write speed from fast to slow. Normally, only the first and second gray squares should appear; If a light gray square (the third square) appears, it takes more time to represent it; if a green and Brown Square (fourth and fifth squares) is present, the exception is read here, but there is no bad way; if there is a red square (sixth, That is, the last square), which means the difficulty of reading here, is about to produce a bad way; if there is a question mark, then the error is read here, there is a serious physical bad, unable to repair. If a red X appears, it means that the error is read here, there is a bad way, can be repaired, or can be blocked.

11, before testing, be sure to prepare paper and pens, remember the hard drive bad road location, if the hard drive bad road slightly more, in the lower right corner is not complete. As pictured, the location of the bad track in 91545

12, after the hard drive scan is over, press F4 appearance interface, select the first item, select Start LBA, enter 90000, and then select Remap, hit enter, the option to On,remap is the bad way to add bad road interval table, shielding bad road speed is very fast, do not see the shielding process on the screen is over, In accordance with this method, the remaining bad way to shield

This method is only used for less bad hard drive, and after shielding the bad way often will appear unexpected results, and finally do not forget in the motherboard BIOS to the hard disk mode to AHCI mode!!!

MHDD Low Lattice method

1, HDD low lattice to solve some problems useful, such as malignant virus, logical bad way

2, press Esc key, appear this interface, then enter erase confirm

3, input 0, confirm.

4, then MHDD will be on the computer hard drive bad way to repair.