Quickly connect two golden wave routes to the Internet

You can use other configuration methods to quickly connect two golden wave routers to the Internet at the same time. Here we will introduce the fastest method, two vrouters can connect to the Internet in just a few minutes. Here we use two vrouters as an example. In the two router connection methods such as www.2cto.com, vro1 1 provides the physical, data link, and network layer, while vro1 1 is a hub, and vro2 2 acts as a vswitch, vro2 2 can be viewed as a vswitch, that is to say, the computers in the room actually belong to vro1 1, the fixed IP address allocated from the router connection cannot be assigned to vro2 2, which is only used as the vswitch at the same time. Www.2cto.com 1. Start the DHCP service of vro1 1. Then you will obtain the IP address of the LAN port allocated to you by vro1 1. Note that vro2 2 only acts as a vswitch here. 2. Divide the IP address of vro1 1 into two subnet segments. By setting the subnet mask, your subnet from 2 to 1, vro2 2 provides the routing function and DNS server. 3. vro1 IP Address Setting: vro1 1 is used to pull a line from the LAN port of vro1 1 to vro2 2, which is inserted into the LAN port of vro2 2, instead of the Ethernet port, the CIDR Block of the computer must be the same as that of vro1 1. The Gateway is the IP address of vro1 1. vro2 2 can be ignored no matter what it is set. It is equivalent to only one vswitch. After the above settings, we can quickly connect the two routers to the Internet. In fact, the router connection is a switch without using the WAN port. You can directly use the switch cascade.