Sun Fire V890, check SDS device status display requires maintenance

The command line output is as follows:

D1600:mirror
Submirror 0:d1606
State:needs Maintenance
Submirror 1:d1616
State:needs Maintenance
Pass:1
Read Option:roundrobin (default)
Write Option:parallel (default)
size:20494464 blocks (9.8 GB)
1600: The Mirror
0 sub-Mirrors: 1606
Status: Maintenance Required
1:1616 Sub-Mirrors
Status: Maintenance Required
By: 1
Reading options: Looping (default)
Write options: Parallel (default)
Size: 20494464 pieces (9.8)

D1211:submirror of d1200
State:needs Maintenance
Invoke:metasync d1200
size:40968576 Blocks (GB)
Stripe 0:
Device Start Block Dbase State Reloc Hot Spare
C1T1D0S1 0 No Okay Yes
d1211: d1200 of the sub-mirror
Status: Maintenance Required
Reference: Metasync d1200
Size: 40968576 pieces (19)
Stripe 0:
Device Boot block dbase state relocate hot spare
C1t1d0s1 0 bad, yes.

Device Relocation Information:
Device Reloc Device ID
C1t1d0 Yes Id1,[email protected]
C1t0d0 Yes Id1,[email protected]
Device Layout Control information:
Device ID Relocation Device
Yes c1t1d0 SSD n5000cca004223864 @ 1
Yes c1t0d0 SSD n5000cca004210578 @ 1

······· Preliminary judgment is the hard drive is bad, but to the computer room to see the service no equipment failure alarm, two big God Judge no big problem, is not doing parallel or parallel failure

This article is from the "Walk Walk" blog, please be sure to keep this source http://10781099.blog.51cto.com/10771099/1789222

Sun Fire V890, check SDS device status display requires maintenance