The solution of error floopy disk fail

Recently, a user in the computer when the self-test, and then the error floopy disk fail,press F1 to Enter the Setup (as shown in the following figure), what is the cause of this phenomenon? Below give everybody analysis under boot error floopy disk fail solution.

Reminder: Del is a hotkey to enter the BIOS setup interface, and some models may be F2 or F1.

When booting from a self-test, if this error occurs, the self-test encounters an error, you can press the "F1" key to continue, or you can press "DEL" to enter the BIOS setup interface to check if the settings are incorrect.

The hint of such information does not represent a real fault. It is only a part of the problem that accompanies the self-test, as long as it is used to remind the user to choose to continue or correct the error. The real fault, but also the most specific and most critical, is the information before the error. The typical error message looks like this:

1. Floopy disk (S) fail

2, Primaster hard Disks.m.a.r.tstatus Bad

3, Primary master hard disk fail

4, System CMOS Checksum Bad

5, 0135:system FAN failure

6, keyboard error or no keyboard present

7, 0135:gpu FAN failure

8, 0134:cpu FAN failure

9.0701:usb over current on Hc/port

10. CMOS time and Date not Set

11. Memory Parity Error at xxxx

12, CMOS Battery State Low

In the actual work environment, this phenomenon is mainly for the following reasons:

1. Hard Drive failure

2. Floppy drive failure

3. Incorrect setting in CMOS Setup or modification of settings

4, the current host is not connected or the keyboard is not detected

5, the fan of the host is not working properly

6. USB Power supply failure

7, the host date, time error

8. Memory Checksum Error

Wait a minute...

This informational tip is not a failure, so there are no documents specifically designed for this information to be incorrectly queued. If you need to deal with a self-test error problem, please check the information before the specific error, according to the key error information to find the document again targeted treatment.

About the power-on error floopy disk fail solution is introduced here, if the tutorial method is still unable to be resolved, then it is recommended to reload the system or the computer to the repair shop to detect maintenance.