The technique of designing business card typesetting with CorelDRAW

Q: What are the main points and precautions for designing business cards with CorelDRAW?

A: Using CorelDRAW to do business cards seems simple, in fact, there are many problems to pay attention to. At first I used a computer to add a inkjet card when at least hundreds of of the waste of business card paper, did more than half a year, just to do business cards have a better grasp.

Points:

The design of a single card for general printing is very simple, and attention should be paid to the chromatic problem.

The whole version of the business card is usually printed on a sheet of paper 10 card, pay attention to the business card standard (55x90mm) in the middle to leave 1MM spacing, for cutting knives. The best set of corners around the corners for alignment. In the middle and up and down also need a vertical line for the first crop.

If it is a printing business card, you can do 10 typesetting use, location: Horizontal 98mm, vertical 57.5mm to make 10 sets and then 10 sets on the center of the page, so as to facilitate the cutting business card machine. (Coreldraw9: Arrangement-deformation, CORELDRAW12: Arranging---transforms)

Attention matters

If it is to do offsctdruckereien business card, pay attention to color not too much, more color on a more money. Note that a small icon do not mix too much color, or may appear overprinter inaccurate problem, preferably in the form of distance color block, do a good job after the output black sulfuric acid paper can be.

If the use of spray black or hit, one-sided business card is more convenient, if you are a card printing, you need to slowly adjust the printing margins, to try more than a few times. However, I think this practice is not much, most of the use of the black card is the name of the cards on the card paper lined up 10 cards together with a business card cutting machine to cut. Here are some points to note:

1, Business Card Standard specification is: 90x55mm, pay attention to your cutting machine, the normal standard, you press 90x55mm arrange the business card to the best will appear more and more small situation, there may be the best one only 45MM is also possible, so the size of the business card is best set 90x56 or 57MM, Make sure there is room for bleeding.

2, the layout of the time, pay attention to the upper and lower plus a printed output of the cross or vertical short line, to ensure that in the cut in split between the middle can be aligned, in addition, four corner to set a 90-degree symbol angle, the last cut paper to be aligned with.

3, one-sided business card cutting attention to the middle position, the other hand clean cut off, in addition, the general business card cutting machine can only be 5 pieces below, too thick easy to walk paper, appear burrs, pay attention to the finished products do not have teeth ah.

4, two-sided business card should pay special attention to the alignment problem. Because for inkjet printers, the image you choose to center out is not necessarily centered. Face down dozen, reverse to fight, but also pay attention to the margin, according to their own printer more than a few times, in print preview fine-tuning good bleeding and left and right margin again output, general a box of cards 10 pieces of paper, first prepared 11 or 12, waste one or two is inevitable. After the law is ascertained, everything is much easier.

Next section question: How do I extract the color value of a bitmap in CorelDRAW?