Procedure:
Press F1 to enter the BIOS, find the Config-USB-USB3.0 Mode in BIOS, change the default Auto option to Disabled, and then press F10 to save.
If the USB mode still does not work, press Shift + F10 on the system installation interface and run the diskpart command to clear the disk if no data exists in other partitions, and convert the MBR partition format before installation.
The 60 series model (sixth generation CPU model) does not have the USB3.0 mode option in the BIOS. Please add the USB3.0 patch.
Tip: This solution is only applicable to Intel chipset models. AMD chipset models cannot be used.
The document states that the Windows 32-bit system is supported, but some 32-bit systems may have problems. We recommend that you install Windows 64-bit systems.
Step 1:
Download the Windows 7 USB3.0 Creator utility from the Intel Official Website>
Step 2:
Use Windows 7 usb dvd Download Tool or UltraISO to create the original Win7 installation disk. (
Do not create images using the ghost image. Otherwise, an error will be reported later.)
Step 3:
To decompress the downloaded software, run installer_creator.exe on the right of the decompressed tool;
Step 4: click the select button on the right of the page to select the partition where the USB flash drive is located;
Step 5:
Click Create Image to start adding a program to the USB flash drive. The process will be long. The official Intel data is 15 minutes, and the actual measurement is over 20 minutes;
Step 6:
When Upadte finished Appears! After the USB flash drive is created, you can use the USB flash drive to install the system on the USB 3.0 interface.
The system USB driver is automatically installed after the patch is installed on the USB flash drive.
Tip: If a USB device (for example, a USB flash drive) cannot be identified when Windows is installed in the system, replace the USB preparation tool,The procedure is as follows:
How to modify Win7 for Skylake platform models
Preparations:
1. Images installed on Microsoft's original Windows 7 64-bit system are not supported by Ghost images.
2. Refer to"
How to create a USB flash drive and how to install the operating system using a USB flash drive".
Recommended Method 2: use UltraISO to write the system image in 1 to a USB flash disk. The size of the USB flash disk is 4 GB or larger,
This operation will clear the data in the USB flash disk. Before the operation, back up the personal important data in the USB flash disk in advance..
Note: The above Windows system images and UltraISO software are both paid licensed software and cannot be downloaded due to copyright issues. UltraISO officially provides a free trial version, which can be downloaded at: http://cn.ultraiso.net/xiazai.html.
Procedure:
1. Download tool
Tool name: Windows USB Installation Tool
Supported operating systems: Windows 7 32bit and Windows 7 64bit
Tool capacity: 7.73 MB
Click here to download>
2. Right-click the downloaded tool and select "decompress to current folder ";
3. Open the "WindowsImageTool" folder generated after decompression;
4. Right-click "WindowsImageTool.exe" and select "run as administrator ";
5. Follow the arrow instructions and text instructions below;
6. The production process takes several minutes (the image size depends on the USB flash drive write speed. Please wait );
7. The "Creating Windows USB Installation Disk is complete" prompt indicates that the table operation has been completed. Please click "Close" to Close the tool software.
