Use PS to bring photos blue-yellow image Color Rendering method

Original

< small map view big picture >

Final effect

1, open the original material, press CTRL + J to copy a layer of background layer. Enter the channel panel, select the green channel, press CTRL + A all, and press CTRL + C to copy. Select the blue channel and press CTRL + V to paste. Point RGB Channel, return to the layers panel, the effect of the following figure. This step quickly turns the picture into a two-color one.

< map 1>

2, create hue/saturation adjustment layer, the red and cyan adjustment, parameter settings such as Figure 2, 3, the effect is as Figure 4. This step turns the background cyan to blue and red to orange red.

< map 2>

< map 3>

3, create curve adjustment layer, the blue adjustment, parameter settings such as Figure 5, the effect is shown in Figure 6. This step adds yellow to the picture.

< map 5>

< map 6>

4, press CTRL + ALT + ~ Up the high light selection, create a new layer fill orange yellow: #F9AC32, blending mode to "soft light", the opacity to: 20%, the effect of the following figure. This step enhances the warm color of the picture.

5. Press CTRL + ALT + + to bring up the high-light selection, press CTRL + Shift + I to select it. Create a new layer fill dark cyan: #0B141B, blending mode to "strong light", the opacity to: 50%, the effect of the following figure. This step adds cyan to the dark part.

< map 8>

6, create color balance adjustment layer, shadow and high light adjustment, parameter settings such as Figure 9,10, the effect is shown in Figure 11. This step is to fine-tune the color of the dark part and the high light.

< map 9>

< map 10>

7, press CTRL + J to copy the current color balance adjustment layer, the opacity to: 80%, the effect of the following figure.

< map 12>

8, create an optional color adjustment layer, white, black adjustment, parameter settings such as Figure 13,14, the effect is as shown in Figure 15. This step strengthens the color contrast of the picture.

< map 13>

< map 14>

9, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Press CTRL + Shift + U to color, blending mode to "multiply", opacity to: 50%, add layer mask, with black brush to rub out the middle part, the effect is as follows figure.

< map 16>

10, a new layer, stamped layer. Execution: filter > Blur > Gaussian blur, the value is 5, after the layer blending mode is changed to "soft light", the opacity to: 10%, the effect of the following figure. This step is appropriate to the image of the soft processing.

11, create brightness/Contrast adjustment layer, appropriate to increase the whole picture contrast, parameter settings such as Figure 18, the part of the bright parts with a black brush out, the effect is as Figure 19.

< map 18>

< map 19>

12, a new layer, stamped layer. Select the familiar method to sharpen the picture, the effect of the following figure.

< map 20>

Finally, fine-tune the overall color, complete the final effect.