What to do if you display a blue screen after mounting the system

Now many users install the system is the use of a key U-Disk System This method, as long as the U-disk can be easily done. However, after the installation is turned on but the display is blue screen, which makes a lot of users are very distressed. Then the U disk installed the system after the display blue screen what to do? Let's look at the specific solution below.

The following figure shows the flash drive installed system after the blue screen display, the main reason for this situation is largely due to the computer BIOS hard disk mode and the operating system are incompatible with each other, the specific solution is as follows:

If the use of the computer is not the same, then the operation of the BIOS steps are also different, of course, today mainly in award BIOS for example, when came to the BIOS after the Operation screen as shown below:

When you find the "Integrated peripherals" option in the image above, simply click the ENTER key and then find the "PCH SATA Control Mode" option and the 3 selection modes shown in the image below will be displayed directly:

The AHCI mode is mainly in the face of the Win7 system compatible hard disk mode, while the RAID mode is the use of multiple hard disk in the premise of the disk array mode, and the other IDE mode is installed on the XP system compatible hard disk mode. Specifically, according to their own system to select the corresponding hard disk mode.