linux 添加swap 分區

Linux Add a Swap File – Howto

by nixCraft on
May 18, 2006 · 34 comments· last updated at
January 4, 2012

I need additional swap space to improve my system performance. How do I add a swap file to Linux system using command line options?

In Linux, as in most other Unix-like operating systems, it is common to use a whole partition of a hard disk for swapping. However, with the 2.6 Linux kernel, swap files are just as fast as swap partitions, although I recommends using a swap partition. The
administrative flexibility of swap files outweighs that of partitions; since modern high capacity hard drives can remap physical sectors, no partition is guaranteed to be contiguous. You can add swap file as a dedicated partition or use following instructions
to create a swap file.

Procedure To Add a Swap File Under Linux

You need to use the dd command to create swap file. The mkswap command is used to set up a Linux swap area on a device or in a file.

Step #1: Login as the Root User

Open a terminal window (select Applications > Accessories > Terminal) or login to remote server using the ssh client. Switch to the root user by typing su - and entering the root password, when prompted

Step #2: Create Storage File

Type the following command to create 512MB swap file (1024 * 512MB = 524288 block size):
# dd if=/dev/zero of=/swapfile1 bs=1024 count=524288
Where,

1. if=/dev/zero : Read from /dev/zero file. /dev/zero is a special file in that provides as many null characters to build storage file called /swapfile1.
2. of=/swapfile1 : Read from /dev/zero write stoage file to /swapfile1.
3. bs=1024 : Read and write 1024 BYTES bytes at a time.
4. count=524288 : Copy only 523288 BLOCKS input blocks.

Step #3: Set Up a Linux Swap Area

Type the following command to set up a Linux swap area in a file:
# mkswap /swapfile1
Setup correct file permission for security reasons, enter:
# chown root:root /swapfile1
# chmod 0600 /swapfile1
A world-readable swap file is a huge local vulnerability. The above command make sure only root user can read/write to the file. Finally, activate /swapfile1 swap space immediately, enter:
# swapon /swapfile1

To activate /swapfile1 after Linux system reboot, add entry to /etc/fstab file. Open this file using a text editor such as vi:
# vi /etc/fstab

Append the following line:
/swapfile1 swap swap defaults 0 0
Save and close the file. Next time Linux comes up after reboot, it enables the new swap file for you automatically.

How do I Verify Swap is Activated or Not?

Simply use the free command:
$ free -m

See also:

• Linux display system hardware status information gathered from /proc filesystem in easy format (includes swap info)

Page last updated at 2:39 PM, January 5, 2012.

PS：本文來自於

http://www.cyberciti.biz/faq/linux-add-a-swap-file-howto/