A dream old tree filled with golden apples

The difficulty coefficient of this tutorial is large, there are many parts of the operation is very fine. If the trunk part itself does not have a branch, it needs to be reproduced with a paintbrush and stamp tool. At the same time the bottom of the tree does not have the soil, needs to use the brush and the layer style to make. In addition to these there are a lot of light and dark parts need to be adjusted, the synthesis must have patience.

Step/Method 1 Create a new size customized document, and open the old tree material dragged in.

2 use a pen to pull out the trunk part, into the selection after adding a layer mask, the following figure.

3 download Some tree brush, then brush the branches with a brush, as shown below.

4 Pull up the branch constituency, and then use the Stamp tool to copy the bark of the trunk, the effect of the following figure.

5 Add layer mask to the tree layer, select bevel and Emboss, gradient overlay, and set the parameters as shown below.

6 Create a new layer, seal the layer, and use the stamp tool to repair the joint in nature.

7 Create a new layer under the stamped layer, add some small branches, the precision is not high with the smudge tool to complete.

8 back to the background layer, use the gradient to pull out the effect shown in the following figure.

9 Image > Adjustment > Black and White, select "Green channel".

10 Add a layer mask, with a lower transparency black brush to wipe the top of the transition, the following figure.

11 Add the layer style shown in the following illustration.

12 Copy the current layer, clear the layer style after the execution: filter > Sketch > Chrome yellow.

13 change the current layer blending mode to "color Dodge" to enhance the texture of the surface.

14 Open the Sky material, drag in, properly adjust the size and position. To color after the layer blending mode to "overlay", the opacity to: 60%, the effect of the following figure.

15 Add a layer style to the sky layer and select a gradient overlay, as shown below.

16 Create a new layer, use the elliptical marquee tool to draw a semicircular selection at the bottom of the layer, fill the white with the appropriate feather, then add the layer style, set the gradient overlay, and set the color to yellow to brown, as shown below.

17 Select your own Starlight brush, then bring up the Brush settings panel, set the parameters below, and brush the starlight around the tree.

18 Brush on some small dot brush.

19 Add a layer style for the dot layer, and the parameter is set as shown below.

20 Create a new layer to increase the light point next to the root.

21 Add the layer style shown in the following illustration.

The same light points are added to the 22 branches.

23 the same method to add dark parts and high light points to the tree, as shown below.

24 Open the Apple material, pull out and then copy in, go to color after adding external glow and gradient overlay style, into the Golden Apple, the following figure.

25 finally copy the Apple in a different position to complete the final effect.

Note : More wonderful tutorials Please pay attention to the triple Photoshop tutorial section, triple PS group: 182958314 welcome you to join