Canceling the win7 computer boot detection hard Drive method

As we all know, Win7 computer in the boot time is will detect a lot of computer data, equipment, although this is a safe behavior, but at the same time will make the computer boot speed is very slow, some unnecessary hard drive to see, we may wish to omit the good!

Method One, or you in the BIOS setup to select every boot to detect the hard drive, and your computer configuration is not related. The solution is to press Del to enter the BIOS after power-on, select quick power On Self test (Fast power-on self-test), your must set to Enabled, select Disabled, turn it off on the line.

Method Two, if the partition is the FAT32 format, it is recommended to convert it to NTFS, the action is to open a command prompt and enter: Convert X:/fs:ntfs, enter;

Method Three, if it is due to abnormal shutdown, if you skip every time will still run, if it is not such a reason to check the state of the D disk is normal, fixed the hard drive error, the specific method is: Click "Start" → "run" in the window, enter "chkdskx:/f" ( X is the disk character, this command can check for logical errors in the file system. and repair, and then start "Disk defragmentation" to defragment the appropriate disk, you can eliminate the disk scan again, it is possible that the hard drive has a bad way, the easiest way is to back up the D-disk data, Then format the D disk so that you can use it properly.

Method Four: Modify the registry, open the registry, navigate to [Hkey_local_machine/system/currentcontrolset/control/session Manager], and locate the "BootExecute" in the right-hand window. : REG_MULTI_SZ ", the key value is windows about disk scan, double-click" BOOTEXECUTE:REG_MULTI_SZ "to change its contents to:" AutoCheck autochk * ", enter can return to normal state, or delete all of the numerical data in it, so that you can completely prohibit illegal shutdown and restart when the disk scanner.

Method Five, open computer and then right-click X Disk Select Properties-Select Tools-Check in error "Start check"-select "Automatically fix file system errors" and "scan and attempt to recover bad sectors", then click "Start" for scan repair.